GripSert

Superior low profile holding power!

gripsert

 

With only 3.5mm of clamp surface needed to securely hold the workpiece, TG-type GripSert workholding inserts are ideal for 5-axis machining operations. Because of the geometry of the grippers, TG GripSert workholding inserts create a pull down effect that prevents any lifting of the workpiece while clamping. These durable inserts combine a tough-coated cemented carbide with specialized teeth and triangular shapes that penetrate different types of workpiece material including steel, hardened steel/titanium (up to 50-54 HRC) and aluminum.

 

TG GripSert workholding inserts offer many advantages over traditional clamping systems including exceptional clamping stability, no need for pre-machining or dovetailing workpieces, vibration dampening and allowing for very secure holding at lower clamping forces to avoid deforming the workpiece. This results in a higher cutting rate and less waste of materials than traditional clamping systems. GripSert tools, jaws and other accessories are available in addition to the TG GripSert inserts for steel, steel/titanium or aluminum workpieces.

BENEFITS

 

effective

EFFECTIVE

Low profile? Our ultra low TG GripSert inserts offer an effective gripping solution for your application.

efficiency

EFFICIENT

Increase speeds and feeds with powerful hold of our workholding grippers.

economical

ECONOMICAL

Save your jaws! Our easily replaceable workholding grippers are the ideal contact wear surface for vise jaws, collet jaws and more.

 

Line up

TG GripSert Covers

Prevent dirt and debris from building up inside the TG GripSerts slots.

TG GripSert Inserts

For steel, steel/titanium or aluminum workpieces.